Status LED Indication

Zivid Two

Zivid Two camera contains three status indication LEDs:

• Power

• Ethernet Link

• Ethernet Activity

The following image describes what the LED colors indicate.

Note

The Speed indication LED shows the link speed between the camera and the network device it is connected to, not the image transfer speed between the camera and the PC. Suppose the camera is connected to a 10G network switch that is connected to a 1G network card. The LED will indicate a speed of 10G even if the end-to-end link speed is limited to 1G.

Zivid One+

Zivid One+ camera contains one status indication LED with four different indication modes:

Color	Indication	Status
Blue	Rapid blinking	No USB connection
Blue	Continuously on with short off period	USB is enumerated and the USB device drivers on the PC are installed and working
White	Continuously on with short off period	Zivid Software is communicating with the projector and “heartbeats” are being received
Red	Blinking	Error [1]

Note

Older Zivid One+ cameras have a thick black rubber gasket so indication LEDs are not visible.

[1]

For Rev-C Zivid One+ cameras with SDK version 2.3 or lower, there is an errata causing the status LED to be red even if the camera is properly working. You should rely only on error messages from SDK.